| Parameter | Associated MIB variable |
Description |
| Subdevice | cbftf150SubDeviceIndex(1) | See BIA, Slot, and Subdevice |
| BIA | cbftf150BiaIndex(2) | See BIA, Slot, and Subdevice |
| Slot | cbftf150SlotIndex(3) | See BIA, Slot, and Subdevice |
| Group Membership | cbftf150Groups(4) | See Configuration Management |
| Marketing Revision | cbftf150MRevision(5) | Marketing Revision |
| Config Match | cbftf150CfgMatch(6) | Configuration Management match? |
| Serial Number | cbftf150SerialNumber(7) | Serial Number reported by hardware |
| Configuration Mode | cbftf150ConfigMode(8) | Configuration Mode |
| Firmware Revision | cbftf150FirmwareRevision(9) | Firmware Revision of the switch |
| Form Factor | cbftf150FormFactor(10) |
A code corresponding to a physical configuration of the product. This code indicates the number of slots occupied and the number, type, and location of media connectors present. For details, see the MIB Module file.
|
| Autonegotiation | cbftf150AutoNegotTbl(11) | Autonegotiation configuration. Enabling autonegotiation on this device
also enables pause advertising. |
| Duplex | cbftf150FullDuplexTbl(12) |
Possible values are fullDuplex(1), halfDuplex(2),
and negotiating(3).
This is either a configuration setting that
controls the duplex mode (when autonegotiation
(cbftf150AutoNegotTbl) is disabled,
or a status indication showing the duplex mode decided upon during negotiation (when autonegotiation is enabled - Twisted Pair ports only).
When link is down, autonegotiation has not been completed yet, and the duplex mode is therefore unknown
and the value returned is negotiating(3). |
| Speed | cbftf150100MbpsTbl(13) |
Possible values are 100Mbps(1), 10Mbps(2), and negotiating(3).
On fiber ports, this variable has the read-only value
100Mbps(1). For twisted pair ports, it is either a configuration setting that
controls the link speed (when autonegotiation
(cbftf150AutoNegotTbl) is disabled,
or a status indication showing the link speed decided upon during negotiation (when autonegotiation is enabled).
When link is down, autonegotiation has not been completed yet, and the link speed is therefore unknown
and the value returned is negotiating(3). |
| TX/RX Pairs | cbftf150CrossTbl(14) | Configuration for automatic correction of TX/RX pairs.
Twisted Pair ports only. When Autonegotiation is disabled, the copper port is placed in MDI-X mode.
When Autonegotiation is enabled, the copper port can be forced into MDI-X mode, or allowed to
resolve TX/RX pair errors automatically. The port cannot be forced to MDI mode.
See also: autonegotiation |
| Far End Fault | cbftf150FarEndFaultTbl(15) | Far End Fault configuration. When autonegotiation is disabled, far end fault is also
disabled. Otherwise, it can be configured via this MIB variable. |
| Media Connector | cbftf150ConnectorTbl(16) | Connector Type reported by device |
| Link | cbftf150LinkTbl(17) | Port link status |
| Ports | cbftf150PortCount(18) | The total number of ports contained in this device |
| Cache Clean | cbftf150CacheClean(19) | Configuration changes pending? |