Media Conversion, Switching and Data Networking by Transition Networks

100BASE-FX to 1000BASE-SX/LX/BX Bridging
Point System™ Slide-In-Module Media Converters

CFBRM13xx-1xx

Data Sheet [PDF]	Installation Manual [PDF]
Quick Installation Guide [PDF]	USB Driver [ZIP]
MEF 9 Certification	MEF 14 Certification

Features

Applications

Specifications

Ordering Information

Two selectable remote management modes:
- IP-Based remote management
- In-Band OAM 802.3ah (remote device managed by local peer)
SNMP v1, v2*
(*Future firmware upgrade; Please contact Transition Networks for upgrade availability.)
AutoCross™
Automatically detects and configures the twisted pair port on the converter to the correct MDI or MDI-X configuration.
Auto-Negotiation (802.3u)
Allows devices to perform automatic configuration to achieve the best possible mode of operation over a link.
Pause (IEEE 802.3xy)
Pause signaling is an IEEE feature that temporarily suspends data transmission between two devices in the event that one of the devices becomes overwhelmed.
Transparent Link Pass Through
Transparent Link Pass Through sends a link-loss signal over the fiber, instructing the remote converter to shut down the copper port—thus notifying the end device—while maintaining the fiber link between the two converters.
Far End Fault (FEF)
A troubleshooting feature that is generally used in conjunction with Link Pass Through to notify both end devices of a loss of link.
Remote Loopback
This feature puts a converter in a special mode that enables the device to loop back the signal from the RX port to the TX port on either media for testing and troubleshooting purposes.
IEEE 802.1p™ QOS packet classification with four egress queues
Ipv4 IP TOS and DiffServ QOS classification, IPv6 Traffic class
IEEE 802.1q™ VLAN, 4096 entries
Static MAC, 64 entries
Double VLAN tagging (QinQ)
IEEE 802.1x™ Port based security
RADIUS client
RMON counters for each port
Bandwidth Allocation (per port)
An important feature found on select converters which allows network administrators to set the bandwidth of the converter to 64KB increments via SNMP management.
DMI Optical Management
IPv4 IGMP v1/v2 snooping
USB port for basic setup
Cable diagnostic function for TP ports
8K MAC addresses
Remote Firmware Upgrade

Note: 100BASE-FX Multimode ST or Single Mode SC for up to 120 km available upon request. Please contact Transition Networks for details.

100BASE-FX to 1000BASE-SX/LX/BX Bridging Point System™ Slide-In-Module Media Converters

Features

Applications

Specifications

Ordering Information

100BASE-FX to 1000BASE-SX/LX/BX Bridging
Point System™ Slide-In-Module Media Converters